Kramer-electronics RB-6 Manual do Utilizador descarregar pdf (Página 11)

RB-6 - Defining the RB-6 6 Channel Power Controller

The following table refers to both Figure 1 and Figure 2.

Feature

Function

IR Receiver

Infrared remote control sensor

IR LED

Lights yellow when receiving commands from the IR remote control

transmitter

POWER LED

Lights green when the device is powered on

ACTIVE OUTPUTS

Buttons (1 to 4)

Press a button to turn on the output. The relevant button LED lights

red.

Press the button again to turn the output off. The button LED no

longer lights

ACTIVE

OUTPUTS 5

Controls

MAX

Press to set the output voltage to maximum. Press and hold to set

the current setting as the maximum voltage

MIN

Press to set the output voltage to minimum. Press and hold to set

the current setting as the minimum voltage

Rotary

control

Turn clockwise to increase or anti-clockwise to decrease the output

voltage

ACTIVE

OUTPUTS 6

Controls

MAX

Press to set the output voltage to maximum. Press and hold to set

the current setting as the maximum voltage

MIN

Press to set the output voltage to minimum. Press and hold to set

the current setting as the minimum voltage

Rotary

control

Turn clockwise to increase or anti-clockwise to decrease the output

voltage

PROGRAM Switch

For the use of Kramer service personnel only

RS-232 9-pin D-sub

Connector (F)

Connect to an RS-232 controller, such as a PC (see Section 6.3)

REMOTE IR 3.5mm

Opening

For installing the optional external IR receiver 3.5mm mini jack (see

Section 3.1)

ETHERNET RJ-45

Connector

Connect to a remote PC controller over a LAN (see Section 6.2)

OUT 1~4 Power Sockets

Plug in devices to be controlled only on and off

OUT 5~6 Power Sockets

Plug in devices to be controlled on/off, and a dimming function using

the minimum/maximum rotary controls (see 5 and 6)

IN—POWER—ON

Power Socket

Connect to the mains power

Mains Fuse

Fuse for protecting the RB-6

Mains Switch

Switch for turning the device on and off

RESET Switch

Press and hold while turning power on to reset the device to factory

default condition

TERM RS-485 Switch

Push up to terminate the RS-485 bus (see Section 6.4)

RS-485 3-pin Terminal

Block

Connect to a controller equipped with an RS-485 port (see

Section 6.4)

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 37 38

Comentários a estes Manuais

Sem comentários

Kramer-electronics RB-6 Manual do Utilizador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Painel de controlo Kramer-electronics RB-6