Kramer-electronics SP-11D Manual do Utilizador descarregar pdf (Página 13)

Connecting Your SP-11D Digital Video Processor

6.2 DIP-Switch Settings

The SP-11D DIP-switch settings are defined in

Table 3 and Table 4:

Table 3: DIP-switch Settings

DIP-Switch

Set as follows:

1 Pedestal ON for pedestal of output signal (7.5 IRE offset selection for NTSC); OFF for no

pedestal

2 HsVs/Cs1 ON for Composite Sync on outputs Hs/Cs and Vs/Cs; OFF for Horizontal Sync on

Hs/Cs, and Vertical Sync on Vs/Cs outputs

3 Secam VBI ON for insert identification signals occupying 9 lines of field-blanking period (only for

SECAM output standard) (bottle pulses); OFF for no insert (no bottle pulses)

4, 5, 6 Test Signals The status of these DIP-switches defines the test signal: see Table 4

7 AGC ON for enabling automatic gain control; OFF for disabling automatic gain control

8 ADDR For selecting one of two machine addresses (defining the machine address)

Table 4: Test Signals

FUNCTION

DIP 4

DIP 5

DIP 6

VITS 330 (Modulated Staircase) – full field mode ON ON ON

No Signal

OFF OFF OFF

Split 75% Bar Generator ON ON OFF

VITS 18 (Multiburst 5.8MHz) – full field mode ON OFF ON

Vertical 75% Bar Generator ON OFF OFF

Inverse Horizontal 75% Bar Generator OFF OFF ON

Horizontal 75% Bar Generator OFF ON OFF

VITS 17 (2T, 20T, 5 Step Staircase) – full field mode OFF ON ON

The example in Figure 4 illustrates how to connect your SP-11D:

1 See the rear panel items 15 and 14 in Figure 1 and Table 2

2 This is the Main mode; test signals are not available

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 22 23

Sem comentários

Kramer-electronics SP-11D Manual do Utilizador Página 13