Kramer-electronics FC-41 Manual do Utilizador descarregar pdf (Página 11)

FC-41 - Connecting the FC-41

5 Connecting the FC-41

Always switch off the power to each device before connecting it to your

FC-41. After connecting your FC-41, connect its power and then switch

on the power to each device.

To connect the FC-41, as illustrated in the example in Figure 3, do the following:

1. Connect the SDI source (for example, an HD-SDI Video player) to the SDI IN

BNC connector.

2. Connect the OUTPUTS:

 Connect the SDI BNC connector to an HD-SDI acceptor (for example,

a non-linear editor)

 Connect the SDI BNC connector to an HD-SDI acceptor (for example,

an HD-SDI display)

 Connect the Y, PB, PR BNC connectors to a component video

acceptor (for example, a plasma display)

 Connect the RGB/HV 15-pin HD computer graphics video connector to

an RGBHV acceptor (for example, a projector)

3. Connect a PC or other controller, if required (see Section 5.1).

4. Connect the power cord (not shown in Figure 3).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 20 21

Sem comentários

Kramer-electronics FC-41 Manual do Utilizador Página 11