Kramer-electronics VP-771 Manual do Utilizador descarregar pdf (Página 59)

VP-771 - Controlling the VP-771

8.3.3.3 Ethernet Port Configuration and Control

Use the Kramer K-UPLOAD software to configure and control the VP-771 via the

Ethernet.

The latest version of K-UPLOAD and installation instructions can be

downloaded from the Kramer Web site at

http://www.kramerelectronics.com/support/product_downloads.asp

8.4 Controlling the VP-771 via the REMOTE Terminal Block

Connector

The REMOTE terminal block connectors include:

 A PIP pin and a G pin which are used for toggling between the Single and

Dual window modes, and for selecting a PiP input

 Nine input pins (defined in the table below) and a G pin for selecting an input

PIN#

Input Source

PIN#

Input Source

PIN#

Input Source

HDMI 1

PC 2

CV 2

HDMI 2

COMP.

PC 1

CV 1

SDI

The contact closure remote control pins operate in a similar way to the INPUT

buttons (see Section 8.1). Using the contact closure remote control (also known as

push-to-make momentary contact) you can select any of the inputs. To do so,

momentarily connect the required input pin (1 to 9) on the REMOTE terminal block

connector to the G (Ground) pin of the REMOTE terminal block connector, as

Figure 34 illustrates.

Do not connect more than one input PIN to the GND PIN at the same

time.

Figure 34: Connecting the Contact Closure Remote Control PINs

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 84 85

Sem comentários

Kramer-electronics VP-771 Manual do Utilizador Página 59