Kramer-electronics VP-443 Manual do Utilizador descarregar pdf (Página 18)

VP-443 - Controlling the VP-443

Mode

Function

FACTORY

RESET

Resets to the default parameters

If you cannot see the display after factory reset, use the front panel Res. button to

set the correct resolution: press continuously for 2 seconds to reset to XGA, or

continuously for 5 seconds to reset to 720p

INFORMATION

Displays the source, the input resolution, the output resolution and the software

version

AUTOSYNC

OFF

Turn the auto sync ON/OFF. When ON, this de-activates the output after a few

minutes if no input is present.

This is useful, for example, when the output is connected to a projector, and the

projector will automatically shut down when it has no input

EXIT

Select to exit the menu

6.2.2 The FINETUNE Menu

Input Signal

Parameter

Function

CV,

COMPONENT

HUE

Set the color hue

SATURATION

Set the color saturation

SHARPNESS

Set the sharpness of the picture

NOISE

REDUCTION

Select the noise reduction: OFF, HI, LOW and MID (middle)

COLOR

FILTER

Set to ON to enable color filtering

May improve the output image for certain graphic cards where

color fringing is seen

VGA

PHASE

Set the clock phase

CLOCK

Set the clock frequency

H-POSITION

Set the horizontal position of the picture

V-POSITION

Set the vertical position of the picture

AUTO TUNE

When set to ON, auto adjusts the image (centers it correctly

on the screen) every time the input is switched to VGA or

when the input resolution changes

Alternatively, you can auto adjust the image by pressing the

ENTER button when not within the OSD menu

COLOR

FILTER

Set to ON to enable color filtering

May improve the output image for certain graphic cards where

color fringing is seen

HDMI

COLOR

FILTER

Set to ON to enable color filtering

May improve the output image for certain graphic cards where

color fringing is seen

DROP LINES

Set it to ON to eliminate the green line (default is OFF)

With some sources (mostly Apple devices) a green line

sometimes appears at the bottom of the display. By factory

default this option is set to OFF.

6.2.3 The AUDIO Menu

Parameter

Function

OUTPUT VOLUME

Set the output volume (from 0 to 100)

Not applicable for embedded HDMI inputs

INPUT VOLUME

Set the input volume (from 0 to 100)

Not applicable for embedded HDMI inputs

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 28 29

Comentários a estes Manuais

Sem comentários

Kramer-electronics VP-443 Manual do Utilizador Página 18

Comentários a estes Manuais

Manuais e produtos relacionados com Instrumentos de medida Kramer-electronics VP-443